Standing seam and metal panel roofing, roof repair and full replacement in Mill Neck. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Mill Neck.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
If two other people have caulked it and it still leaks, call us. Most stubborn leaks turn out to be flashing, a valley, or a fastener nobody thought to check.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Steam and hand work, never a hammer and chisel on your roof. Then we check the eaves for the damage the ice already did.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Hard wind lifts shingles and works panel fasteners loose along the edges, which is exactly where the next storm gets underneath. We refasten, replace and reseal.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Low slope roofs fail at the joints and around anything that sticks through them. That is where we start, not out in the middle of the field.
A limb through the roof or panels peeled back overnight needs covering now, not next week. We get it dried in first so the inside of the house stops taking damage.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
A skylight has to be woven into the roof, not caulked to it. That is the difference between a fix that lasts a season and one that holds.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
We repair what the storm actually broke. If that is one slope, we do one slope, and we will not pad an estimate to make a claim look bigger.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Mill Neck homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Mill Neck home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Mill Neck homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
A few backed out screws or a whole roof off a church — we take both. No job is too small to get the same crew and the same care.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
The questions that come up on just about every estimate we write.
Often, yes. Plenty of the Mill Neck roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
That is most of what leak work is. Water runs along decking and rafters before it ever drips, so the stain on your Mill Neck ceiling is rarely under the actual hole. We work back to the real entry point, fix that, and check the rest of the roof while we are up there.
Sometimes. If the decking is sound and there is only one layer of shingles, a Mill Neck metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
No. Estimates are always free in Mill Neck. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
Much less than people expect. Over solid decking with underlayment under it, a Mill Neck metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
A typical Mill Neck shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Real feedback from homeowners whose roofs we have worked on.
"Hail came through and they had photos and a written estimate to my adjuster in two days. Made the whole claim about as painless as it could be."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
Our crews cover the surrounding area, not only the city limits.